Need help? Talk to an expert
Free +91-22-26731904

Gas Detector

  • Minical Iii Flow Fitting

    minical iii flow fitting

    PROPERTIES A flow-through fitting is preferably used in free outlets of basins, tanks or heating condensers. The robust fitting is easy to install. For protecting the integrated electrodes from a too strong flow and particles, a baffle plate is provided. A cleaning aperture enable fast and easy cleaning. The benefits at a glance Cleaning aperture…

  • Variocon 2010

    variocon 2010

    PROPERTIES The various system of the Variocon amplifier has been designed for providing a compact signal amplifier/controller in line with the market. The measuring amplifier is suitable for measuring physical quantities like pH , redox values or for performing chlorine measurements. The system assures the permanent use in all water treatment plants requiring pH, redox…

  • Minical Iii

    minical iii

    PROPERTIES NH3 detection for cooling circuits Cooling systems with ammonia as coolant need to be continuously monitored for leaks for long-term security of investments as well as for open systems to comply with the environmental standards.  Ammonia is one of the most widely used refrigerants. However, it has a strong irritant and corrosive effect. In…

  • Control Panel Rc2

    control panel rc2

    PROPERTIES Some flammable gases are lighter than air. If a transmitter is installed close to the ceiling, it can be connected to the remote control by a fixed installed cable with plug connection. Thus, all adjustments can be made comfortably from floor level. The control panel can be used to control several transmitters. When using…

  • Gma200-mgss

    gma200 mgss

    PROPERTIES A gas sampling system is required in all places where the gas atmos- pheres cannot be monitored with conventional transmitters and sen- sors. In order to reliably measure gases in narrow pipes under high pressure influence, or in complete closed cycle processes or under extreme temperature conditions, samples of the atmosphere must be first…

  • Transmitter Zd22

    transmitter zd22

    PROPERTIES Superior technology The Transmitter ZD22 is specifically designed for long-term monitoring of oxygen concentrations. The integrated amperometric oxygen sensor is based on an electrochemical oxygen pumping cell made of zirconium dioxide. It is characterized by its robustness, a very high life expectancy and its outstanding long-term stability. The integrated thermostatic control of the sensor…

  • Gma200 Mw4

    gma200 mw4

    PROPERTIES Conception of the Gas detection system GMA200 The gas detection controller GMA200continues with the tradition of thecompany under consideration of innovativetechnology and trend-settingflexibility. It is designed for commercialand industrial applications for themeasurement of combustible andtoxic gases as well as for the measurementof oxygen. The compactconstruction of the GMA200-MW4provides a cost-efficient solution forsafe gas monitoring…

  • The Leak Detector G300 Ii

    the leak detector g300 ii

    PROPERTIES The G300 is specially designed for accurate detection of leakages. If high concentrations arise in the room during detection the G300 warns with a bar graph. Clear and simple display and warning Changing gas concentrations are indicated audibly and visually. The frequency of the audible warning changes with approximation and removal. Leakages will be…

  • Micro Iv

    micro iv1

    PROPERTIES Single-gas detector with data-logger The single-gas detector Micro IV is the systematic further development of the gas detector Micro III with its proven function and safety aspects. Extra functionality enabling also the reliable documentation of work performed in hazardous areas is added. The small and light single-gas detector is the perfect solution for detecting…

  • Dockingstation Ds404

    dockingstation ds404

    PROPERTIES Due to the innovative, easy-to-use docking station DS404, you are in complete control of your portable GfG gas detectors Microtector II G450 and G460. Increased safety through complete documentation Automatic bump tests, calibrating and last but not least a reduced test time help you to save time, gas and money above all. With the help of…

  • Multi-gas Detector Microtector Iii G888

    g888

    PROPERTIES Record-breaking The Microtector III G888 is worldwide the smallest and most light-weighted 4-7 gas measurement device with Bluetooth and radio module. Depending on the sensor equipment, the device will warn against risks caused by toxic as well as flammable gases and vapours as well as against lack and excess of oxygen. By individual sensor…

  • Software Et-view Et-diag

    et viewet diag

    PROPERTIES Features Visualisation: Individual text to identify each measuring point (channel) Indications for operation, alarms, transmitter fault Measuring values with physical unit and gas Indications for ET-8D-status operation, maintenance, fault and data transmission Cycle time for actualization configurable Visualisation of all connected control units simultaneously Data logging: Capacity depends on hard disc only Recorded data…

  • Integral Measuring Concept

    integral measuring concept 1

    PROPERTIES It is often necessary to monitor gas concentrations even in sealed off processes or not accessible areas. Typical applications are for example silo and tank monitoring, land fill gas measurement or bio gas facilities. Direct measurement within these processes is often impossible due to adverse application conditions. Sampling from process gas and external measurement…

  • Transmitter Serie Sens

    sens1

    PROPERTIES Die Transmitter geben ihr Messsignal über einen 4-20 mA Signalausgang mit linearer Kennlinie aus. Die Transmitter bieten Ihnen durch Einsatz modernster Sensortechnik auf Basis der Messprinzipien Wärmetönung  (WT), Elektrochemie (EC), Halbleiter (HL) und Infrarot- Absorption (IR/IR3) optimale Lösungen für fast alle denkbaren Anwendungen. Die Verwendung dieser Serie bietet sich auch an, wenn eine Erneuerung…

  • Transmitter Serie Exsens

    transmitter serie

    PROPERTIES The measuring signal of the transmitters ExSens is a linear 4-20mA signal output. Due to modern sensor technique based on the measuring principles catalytic combustion (WT), electrochemica (EC), semi-conductor (HL) and infrared absorption (IR) these transmitters offer excellent solutions for nearly all thinkable applications. This series is also suitable in case of renovation of…

  • Transmitter Ph-is

    phis2

    PROPERTIES Funktionsmerkmale Messgrösse: pH Messbereich: 0 bis 14 Messprinzip: Glaselektroden, Einstabmesskette Anzeige: 8-stelliges Display zur Messwert- und Meldungsanzeige 3 LEDs für Betrieb (grün), Alarm (rot), Störung (gelb) Relais: 2 potentialfreie Kontakte 24 V / 200 mA (Alarm, Störung) Zusatzfunktionen: Eingaben und Justierung mittels 4 Taster am Transmitter Digitale Schnittstelle RS 485 Einsatztemperatur: 0 °C bis…

  • Transmitter Nh3-20-is

    nh3 20 is4

    PROPERTIES Funktionsmerkmale Messgrösse : Ammoniak (NH3) in Wasser, Wasser-/Glykol, Sole u. a. Flüssigmedien. Messbereich : 0 bis 20 ppm Messprinzip : Ionenselektive Elektrode Anzeige : 8-stelliges Display zur Messwert- und Meldungsanzeige 3 LEDs für Betrieb (grün), Alarm (rot), Störung (gelb) Relais : 2 potentialfreie Kontakte 24 V / 200 mA (Alarm, Störung) Zusatzfunktionen : Eingaben…

  • Control Unit Et- 8d

    control unit et8

    PROPERTIES DA: with display and analogue outputs Features 8 transmitter inputs 8 transmitter inputs 3 alarm levels per transmitter 24 Relay-outputs potential free, freely adjustable Graphic Display for measured values, alarms, messages, information about system and measuring points LEDs for alarms (8X3 red) for operation (8 x green) for fault (8 x yellow) RS-232/RS-485 Interface…

  • Control Unit Et- 4d2

    control units et 4d2

    PROPERTIES Number of Transmitters: 1 to 4 (4-20 mA) Signal Processing: Microcontroller with A/D-Converter Alarm/Fault/Indication: Illuminated graphic display (160 x 80) for indication of measured values, messages and alarms 12 (3 x 4) red LEDs for alarm indication LEDs for indication of channel fault (4 x yellow), channel operation (4 x green), operation (1 x…

  • Control Unit Et-1d

    558bfae79beee

    PROPERTIES ET-1D is the best choice for all measuring tasks with only one measuring point. Our ET-1 offers all advantages of the Control Unit ET-8D, but reduced to one measuring point. Wall mounted housing DIN-Rail Control panel 19”-Rack DA: with display and analogue output PRODUCT DESCRIPTION 1 transmitter inputs 2 digital inputs 2 alarm levels…